Jump to content

Velocity stack

From Wikipedia, the free encyclopedia
Short velocity stacks on a 302 cu.in. Ford FE engine in the tight confines of a Ford GT-40.

A velocity stack, trumpet, or air horn[1] is a typically flared, parallel-sided tubular device fitted individually or in groupings to the entry of an engine's air intake system to smooth high speed airflow, and allow engine intake track tuning to incorporate pressure pulses created by its internal components.

Velocity stacks can be of differing lengths and fitted to both carbureted and fuel injected engines. They are not to be confused with the similarly shaped sound-producing pneumatic air horn.

Function

[edit]
Illustration of the velocity stack principle

The velocity stack is designed to:

  • Allow smooth and even entry of air at high velocities into the intake tract with the flow stream adhering to the pipe walls known as laminar flow.[2]
  • Modify the dynamic tuning range of the intake tract by functioning as a resonating pipe which can adjust the frequency of pressure pulses based on its length within the tract.

Modified engines often have the original air box and associated ducting removed and velocity stacks are installed as accessories.

The length of the stack is known to have a direct effect on a particular engine's boosted power range.

Most current aftermarket stacks are designed to be run "in" the airbox and a company that does research well will have some applications that have all the same length and some applications that have differing lengths of stacks on different cylinders.

It is commonly related that "stand off" (air–fuel mix that gets pushed back out of the port, usually at full throttle / low rpm) is somehow captured by installing a longer intake pipe (stack). However, it is actually that the intake valve is closing too late and the combustion chamber is simply overfilling and blowing back out the intake port, before the intake valve closes. A longer inlet pipe will create a later intake pressure wave that will help keep the air in the chamber until the intake valve closes.

Detailed velocity stack working principle

The acceleration of air flow into a duct is inherently a highly efficient process and the difference between even the crudest radius inlet, and the most aerodynamic shape possible is slight, amounting to no more than a few percent.[3] The flow coefficient of a perfect entry would be 1.0 while the coefficient for a sharp edged entry would be 0.6 and a re-entrant plain pipe 0.5.[4] In practice these latter types of entry are never used for engine intakes. There is always some attempt to provide some radius at the entry. This means that total engine airflow would not increase by the amount suggested by these figures, which apply only to the entry alone, as the inlet end is never the smallest or most restrictive part of the system. Because the greatest losses to flow occur near the valve seat, actual overall gain from any improvement of the entry flow would be much less.

In the real world, on high-rpm IR IC engine, using a minimum amount of inlet radius gives the best wave strength and a power boost of 2% to 4% over a 3000 to 3500 rpm range. Using a larger radius, like 3/4", broadens out the resonant pressure wave rpm range, but the compression boosting pressure wave is greatly diminished and almost unnoticed by the engine.

See also

[edit]

References

[edit]
  1. ^ Shepard, Larry (2010). Rebuild & Powetune Carter/Edelbrock Carburetors HP1555: Covers AFB, AVS and TQ Models for Street, Performance and Racing. Penguin. p. 321. ISBN 9781101171387.
  2. ^ US patent 4066720, "Carburetor Air Intake Velocity Stack", published 1978-01-03 
  3. ^ DESIGN OF AN INTAKE BELLMOUTH -Dr. G Blair http://www.profblairandassociates.com/pdfs/Bellmouth.zip
  4. ^ Internal Flow Systems By Donald S. Miller